United Bimmer Community - BMW Forum

United Bimmer Community - BMW Forum (http://www.unitedbimmer.com/forums/index.php)
-   E46 (http://www.unitedbimmer.com/forums/forumdisplay.php?f=6)
-   -   brake wear indicator reset..... (http://www.unitedbimmer.com/forums/showthread.php?t=6081)

Timboy 01-24-2006 05:41 AM

brake wear indicator reset.....
 
When you've changed the breaks and the brake sensor wire, does that auto reset the warning on the instrument cluster or not???

Dudesky 01-24-2006 08:03 AM

Yes, although sometimes it takes a few starts and stops with the car. If it stays on after 2-3 days of driving, recheck your sensor installation and also check your sensor lines for possible damage.

EnvyM3 01-24-2006 08:34 AM

Be careful when you do it b/c often times you will have to replace the sensors when you replace the brakes b/c the sensor wears out easilly. I know I had to have mine replaed when I had the brakes done.

Timboy 01-24-2006 07:25 PM

I'm putting a new sensor in, it only cost 8 bucks....Thanks guys for the feedback

Cd24747 10-24-2011 12:39 AM

How do you put it in? Where did you get it?

pocojo68 11-02-2012 12:25 AM

Hey. Just follow the cable up to a box infront of strut on driverside,the other end goes in the
pad.On the rear, sensor is on pass. side infront of trailing arm.


All times are GMT -5. The time now is 06:23 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright © 2005-2013 UnitedBimmer.com