United Bimmer Community - BMW Forum

United Bimmer Community - BMW Forum (http://www.unitedbimmer.com/forums/index.php)
-   BMW General Discussion (http://www.unitedbimmer.com/forums/forumdisplay.php?f=20)
-   -   ignition delema (http://www.unitedbimmer.com/forums/showthread.php?t=51376)

stephenking 07-31-2012 11:56 PM

ignition delema
 
just bought my first bmw 1995 318ti

the ignition harness needs to be replaced looks pretty simple the problem is this the two green wire harness the goes to the key switch is broken off the side of the ignition ring, also the key tumbler is shot just spins around needs to be replaced, i know the two green wires are part of a coded key system. my question is this can i get a harness and key tumbler Say with key from my local wrecking yard . is there any way to get the chip out of my old key to make this work. second question is the system going to be lock out because the green wires are ripped off the side of the key cylinder.and was tried to start without those wires being close to the key

DEATH2000 08-01-2012 01:36 AM

You can get a tumbler from the junkyard. You just have to switch over the insides from your tumber so your key will still work, or get the whole car re-keyed. Which is not cheap.

Have you tried starting it since the green wires were disconnected?

stephenking 08-01-2012 09:52 AM

yes i tried starting it with the green wires disconnected it took Mr a while to figure out where they went too
will it be obvious what inside parts will need to be switched over. also is the car going to be locked up because i tried to start with the green wires off?

stephenking 08-02-2012 11:31 AM

any help out there


All times are GMT -5. The time now is 02:23 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright © 2005-2013 UnitedBimmer.com