United Bimmer Community - BMW Forum

United Bimmer Community - BMW Forum (http://www.unitedbimmer.com/forums/index.php)
-   5-Series (http://www.unitedbimmer.com/forums/forumdisplay.php?f=50)
-   -   1995 E34 540i (http://www.unitedbimmer.com/forums/showthread.php?t=39540)

djtrance 01-26-2012 03:49 PM

1995 E34 540i
 
hi,

I just bought a 1995 540i 6 speed manual transmission with a bad clutch. I was told before buying that I needed a clutch kit.
Has anyone worked on anything like this in the past?
I am looking at buying a clutch kit but was wondering if anyone has recommendations.

Thanks

DJ

Big Evil 02-01-2012 11:23 AM

Replace the pilot bearing, throw out bearing and plan on at least getting the flywheel machined if it wasn't toasted by driving w/a bad clutch. Also pay attention to the center support bearing on the driveshaft. They usually need replacing (which would be a driveshaft replacement since the joints are non-servicable)

djtrance 02-17-2012 08:53 AM

Thank you sir.

just got the bearings. I will know the state of the flywheel once I start installation.


All times are GMT -5. The time now is 08:23 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright © 2005-2013 UnitedBimmer.com