Tried to check my diag codes - weird result
I have another question.
I read the sticky about checking for any stored codes via the On key + 5 accel presses.
I followed the procedure and seems to get a strange result.
The Check Engine Light (CEL) flashed to start.
Then it gave a long flash a pause and then a quick flash.
It seems to just repeat this pattern over and over. long flash - long pause, quick flash, long pause - repeat.
Am I just reading it wrong?
Thats the procedure for OBDI cars.
The CEL should flash, followed by a pause, then the flashes for the code (if any). Theirs a couple youtube videos on it, so you can see what it looks like.
Ok, thank you.
The procedure did seem to activate a diagnostic mode (lots of clicking and such) plus the blinking CEL. But I'm going to go with no codes = good.
I don't have any reason to suspect a code, just checking.
By your response I take it mine may not be OBDI?
No yours is OBDI. I was saying that you were correct in that the procedure you used was correct.
Pre 1995 is OBDI. 1996 and newer is OBDII
In other news, some emery cloth, a few new bulbs, and dielectric grease seems to have cleared up my rear light gremlins.
|All times are GMT -5. The time now is 07:36 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2013, vBulletin Solutions, Inc.
Copyright © 2005-2013 UnitedBimmer.com
Ad Management by RedTyger