No Abs - United Bimmer Community

**xxxbimmer** · 04-22-2005, 06:11 PM

m getting the error code 132 (made my abs light come on)

brake censor or something?

ne 1 know where i can get the part...and if i can do it myself

**bitcore** · 04-22-2005, 11:13 PM

Looks like an abs sensor is malfunctioning or your ABS relay is shot. You may want to wait for another reply for more information. I'm fairly inebriated at the momnt but the information I gave is accurite... yet vauge lol.

**xxxbimmer** · 04-24-2005, 04:56 AM

sounds like fun

**thekid** · 04-24-2005, 03:27 PM

That sounds about right. Only problem is you don't really know which one(s) is failing. When did you get your brake pads chagned last? Did you replace the senors at the same time? If so I would check the relay, if not get four sensors and go ahead and change them all, unless you have a way to get all four wheels up off the ground. In which case just change them out until you figure out which one(s) is out. Even if only one is out, these things are cheap and good to have around because most of the ABS lights are from brake sensors. If this doesn't work try the relay. I don't have any diagrams to show you how to do it, but www.pelicanparts.com will most likely have a DIY or a parts diagram that would show you where the sensor is. From there grab a jackstand and your wrenches and find it.

**xxxbimmer** · 04-25-2005, 02:48 AM

i had the sensors replaced.........

the bmw place said it was some sensor that measures how far the pedal is being pushed.......and its near the brake booster........