Power Steering - Fluid refill procedure?
I had the steering rack and power steering pump replaced (the system was bone dry as well)
I bought new fluid from my BMW dealer, and there are no leaks anywhere. Filled it up to the appropriate level in the reservoir and had a friend turn the wheel back and forth until no more fluid was required and air bubbles stopped appearing.
Now, when I turn on the car, it runs for roughly 15-30 seconds before a high pitched squeal is heard and smoke starts appearing from where the pumps pulley is located.
Would anyone know what the official refill procedure is from BMW?
Also, are there any bleeder valve's on the rack or in the system to get out any air that might still be in there?
The fluid also gets very warm only after a short time, and the pump itself gets very very hot to touch.
The car is a 2008 135i Cabriolet, Without Active Steering
|All times are GMT -5. The time now is 02:37 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2013, vBulletin Solutions, Inc.
Copyright © 2005-2013 UnitedBimmer.com
Ad Management by RedTyger