think im gonna attempt the the front bumper tomorrow with the help of a mate (both pretty clueless).will be drilling of new bumper for fixings etc.
can anyone tell me how to repair a split in fiberglass?problem is,its in quite an awkward position to mend. if you can imagine, the split is central on the left side and top edge of the bumper and lands half way across the back wing where bumper meets wing.due to the slight play in fiberglass, in its natural state (sat on my garage floor) it tends to gape open a bit and if i squeeze the split and let go again, it will re-open. im not sure if i should attempt to fit it and hope the gap will close (should do as made for the car) and then use some good filler? any suggestions appreciated. sorry, my first ride and cant be of much help to anyone else at the mo! cheers, martin.